M7 SA-4320 Instrucciones De Uso página 2

Specifications
Spring driven drum: for automatic rewind.
Locking ratchet: to maintain the desiredlength of hose
in use.
Read the following precautions and instructions before
you begin assembly or using. Failure to comply with
theseinstructions could result in personal injury or
property damage. Keep these instructions in a conve-
nient location for future reference.
Hose Reel Safety Precautions
1 Make sure incoming line pressure does not exceed rated operating pressure for your
model hose reel.
2 Use proper eye protection when assembling and using the hose reel.
3 Assemble the hose reel on a clean workbench.
4 Use soap and water when checking for leaks.
5 Keep children away from the work area.
Warning: Exposure of skin directly to pressurized air, or fluid could result in severe
bodily injury.
Installation of Reel
1) For overhead ceiling mounting: Install reels at least 10 feet above the floor.
2) You will need to purchase appropriate hardware for mounting your new reel.
1 The reel base has four 1/2" (or 12.7mm) drilled holes for mounting on a suitable
flat surface. Figure 2 is a template showing the correct location of the 4 mounting
holes in the base.
2 The reel is supplied with a hose guide roller bracket. The bracket position may be
changed depending on the reel mounting position. Figure 2 shows " Typical
Mounting Positions". If bracket position needs to be changed, do the following:
(1) Pull out some hose and let reel latch.
(2) Remove the bolts that attach the guide roller bracket to the support post.
(3) Rotate guide roller bracket to correct position, replace bolts and tighten.
3 Using the four holes in the base, mount the reel in the desired location. Be sure to
use appropriate hardware and tighten securely.
4 Apply Teflon tape or pipe sealant to supply line threads, attach to reel inlet and
tighten. The other end of incoming line can now be connected to desired supply
source.
5 If hose has been supplied with reel: Apply Teflon tape or pipe sealant to outlet
fitting on reel hose, then attach to desired tool, or nozzle. Check connection for
leakage, also check hose reel for correct operation. (Details see Operation section.)
2