M7 SA-4320 Instrucciones De Uso página 4

2 Remove hose stopper from hose, and feed hose back through guide.
3 Wrap the pulled hose one time around the drum to increase tension or un-wrap hose
one time from drum to decrease tension.
4 Re-insert hose through guide, and install stopper onto hose end.
5 Unlatch the Drum and check tension. Pull hose from reel, and adjust stopper position
if necessary.
Replacement of Swivel Seal
1 Turn off and disconnect supply line from swivel inlet.
2 Remove swivel assembly from reel axle.
3 Remove circlip from swivel, and take apart. Note: You may want to remove swivel
from reel hose end, but this in not necessary unless a new swivel is being installed.
4 Replace the seals and reassemble swivel.
5 Use Teflon type or thread sealant on swivel thread fitting, reconnect the swivel thread
fitting with axle.
6 Re-connect inlet supply line.
Replacement of Hose
1 Turn off supply to reel.
2 Pull out all the old hose and lock the reel in this position. Caution: Make sure reel
drum is securely locked and cannot rotate back.
3 Remove two hose clamps from hose.
4 Carefully disconnect hose from swivel joint on side of reel, or male fitting in axle
center and remove old hose.
5 Feed new hose through guide and opening in drum, and connect to swivel. Re-install
two hose clamps, on inside and outside of drum flange. Install stopper on other end
of hose in the same position as before.
6 Carefully release the drum latch, and slowly allow the hose to wind onto the reel.
Note: Final spring adjustment is accomplished by adding or removing wraps of hose
around the drum. (Details see spring tension adjustment).
Spr ing Canister War ning
If the rewind spring fails for any reason: For safety reasons, the manufacturer strongly
recommends the replacement of the spring canister be carried out by a professional
mechanic.
Limited Warranty
1 The manufacturer warrantees this hose reel against defects in material and craftsman-
ship, for a period of 12 months from date of purchase.
2 Hose, if supplied with reel, O-rings, plastic rollers and rubber stopper are deemed to
be normal wear items; not warranted.
3 The warranty does not cover damage caused by accident, misuse or faulty installa-
tion.
4 The reel must be installed and maintained in compliance with the instructions.
4