Special Maintenance - Essilor TIN200 Manual De Instrucciones Y Uso

Réf. man TIN200/TIN400
MAINTENANCE
Any modification affecting the operation or the safety of the machine must be carried out by
the manufacturer's technicians or manufacturer approved technicians. Otherwise, ESSILOR
will not accept any liability for any alterations or damage which could ensue.
In the event of the machine being used incorrectly, or as a result of damage through
operations not listed in the manual, Essilor will not accept any liability.
Any servicing and special maintenance operations must be carried out with the
device switched off and the power supply removed by disconnecting the power
cable.

SPECIAL MAINTENANCE

Special maintenance procedures are carried out in the event of the device stopping
following a breakdown of mechanical or electrical parts.
For safety reasons, the end-user is not authorised to carry out special maintenance
operations. In this instance please contact ESSILOR or an approved Help Desk.
INSTRUCTIONS FOR SERVICE REQUESTS AND SPARE PARTS
In any communication with our Help desk always state the type of machine, the registration
number and the year of manufacture stated on the label which identifies each machine and,
where possible, specify the nature of the problem or the defect presented by the machine.
In order to ensure optimum operation of the device, any replacement parts must be original
spare parts and of the same design and materials.
CLEANING THE MACHINE
Use a damp cloth and a gentle detergent.
Before carrying out this operation, make sure that the device switched off by
disconnecting the power cable.
Infiltration of liquids can damage the electrical parts of the device.
TROUBLE SHOOTING
Problem: The machine is not heating
Possible cause
Spent fuse
The furnaces are not
heating
(*)To check the fuse, turn the main switch to "0" (zero),
disconnect the power cable and open the case.
Remove the fuse and check the integrity of the wiring inside
LE PRÉSENT MANUEL EST LA PROPRIÉTÉ INTELLECTUELLE DE
Instructions and maintenance manual
Rév. 7/2014
Replace the existing fuse inside
the plug(*)
Contact the Help desk
ACTION
TOUTE REPRODUCTION EN TOUT OU EN PARTIE EST INTERDITE
EN
Page 10 sur
32