10520xxx_Rev400_GA_NUK Mipu Tischpumpe BP7.book Seite 32 Donnerstag, 5. April 2018 12:52 12
page 29), or swap the clogged filter for the
replacement filter included in the delivery
package.
14. If milk has entered the tube, immediately
switch off the pump unit using the master
power switch
26, and clean the tube
and the filter 6 (see "5.3 Special cleaning of
tube and filter" on page 29).
After each pumping session
15. Switch off the pump unit 3 by pressing the
master power switch
16. Place the breast shield 9 with the attached
breast milk container 12 in the stand 19.
17. Remove the tube connector plug 7 from
the pump unit 3.
18. Remove the tube 4 from the breast
shield 9.
19. If you used the mains adapter 13
in order to ensure that the device is
completely
disconnected
power.
20. Unscrew the breast milk container 12 from
the breast shield 9.
Make sure you hold the breast milk
container upright while doing so.
21. Clean
the
necessary
immediately
after
pumping session (see "5 Cleaning and
Sterilising" on page 28).
9 Tips for Successful Expressing
Correct expressing takes practice. You will
first need to get used to your new pump.
9.1 Frequency
How often you need to express depends on
the reason for expressing. If you will be
apart from your child and/or want to sustain
milk production, the natural breastfeeding
rhythm should be maintained. You should
therefore express 6 to 8 times daily,
including once during the night. In all other
8.2 Automatic switch-off
If no buttons are touched during operation
(during an active pumping session), the
pump unit will automatically switch to start-
up mode after 30 minutes.
This does not apply when the Memory
function is being used. In other words, once
started, a saved pumping session will
always run through until the end before the
device switches to start-up mode.
If no buttons are touched when the pump
unit is in start-up mode or pause mode, it
26.
will
15 minutes.
8.3 Mobile operation
You can also use the pump while moving
about your room, using the shoulder strap to
carry it.
The shoulder strap is securely fixed to the
unplug it
,
pump unit.
1. Should the shoulder strap need cleaning,
from
mains
2. before reattaching it to the lug 1 on the
Note: The shoulder strap 20 must not be
sterilised.
components
completing
your
8.4 Feeding expressed milk
Screw the feeding teat 15 onto the breast
milk container 12 using the screw ring 16.
cases you should express entirely according
to your personal wishes and requirements.
9.2 Method
Milk should be expressed from each breast
in turn. The different settings you can
choose for your pumping session allow you
to emulate the natural suckling action of
your baby as closely as possible.
• In the "stimulation phase", the rhythm is
32
automatically
switch
detach it from the lug 1, wash it in water
with a little soap or gentle detergent, and
air dry it
pump unit.
rapid and urgent to stimulate the milk
off
after