RCA ANT1100F Guia Del Usuario página 4

Connecting the ANT1100F to Your TV
ANT1100F
Built-In
Coaxial Cable
2
3
TV
Mounting the Antenna to the Wall
Once you've confirmed the best location for your antenna and scanned for channels, you're
ready to mount the antenna to that location, using the mounting strips included. If you
decide to move the antenna after you've mounted it, no problem: the mounting strips
detach from the wall easily, without harming your wall's surface, and are easily replaceable at
most retail and drug stores.
Caution: DO NOT use the mounting strips with wallpaper. The mounting strips may not adhere
well to vinyl surfaces. Apply to surfaces above 50°F (10°C). Adhesive could lose adhesion above
105°F (40°C).
Note: The antenna also has two holes along its top edge for hanging it using screws or tacks (not
included).
To mount the antenna using the mounting strips:
1. Clean the surface of the location with isopropyl rubbing alcohol. Wipe gently, then let
the area dry.
Important: Do not use household cleaners.
2. While the area is drying, separate the mounting strips. Snap them apart length-wise first,
then snap each of the resulting strips in half.
4
1. Make sure your TV is turned off.
2. Connect the ANT1100F's built-in cable to the antenna
input on your TV.
Important: Make sure you uncoil the antenna's coaxial cable
completely. Leaving it coiled will reduce reception performance.
3. Scan for channels on your TV.