Electrical Connection; Guarantee; Environment And Recycling - AEG WKL 502 Instrucciones De Utilización Y Montaje

For the Professional

2.2 Electrical connection

This heater is for 230 V AC.
Please observe national standards, the regulations of your local electricity supply company as well as data
the rating label.
Electrical safety!
The convector heaters have protective system II (
Note the details on the rating plate!
The voltage supply must match the requirements on the rating plate. The supply cable must be correctly
sized. The heater must be connected to a socket outlet or permanent terminal box at least 10 cm to one side
of the heater.
In compliance with installation regulations the permanently wired electrical installation must be provided
with an omnidirectional terminal switching device that has a contact opening gap of at least 3 mm.
To avoid hazards, if the power cord of the appliance exhibits visible damage it must be replaced by the
manufacturer or his service department or a qualified electrician.
Please note in general:
Where the convector heater is fitted in a room with a bath or shower, ensure the safety zone defined in
IEE Regulations is applied in accordance with the details on the rating plate.
Safety measures
This convector heater is equipped with a safety cut-out (STB) that switches the heater off if it overheats.
Once the heater has switched off due to overheating, remove the cause of the fault, e. g. blocked air grids.
When the heater has cooled down for several minutes it will restart automatically. If the heater then cuts
off again, switch off the heater and call an authorised serviceman.
Caution!
Ensure the safety zones (mm) in following figure are kept
free.

3. Guarantee

For guarantee please refer to the respective terms and conditions of supply for your country.
The installation, electrical connection and first operation of this appliance should be carried out by a
qualified installer.
The company does not accept liability for failure of any goods supplied which are not installed in
accordance with the manufacturer's instructions.

3.1 Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with the national
regulations for waste processing.
8
) and are spray protected ( IP24).