Listening To The Fm Radio; Tuning In A Station; Presetting Stations; Tune To A Preset Radio Station - Lenco IPT-100 Manual De Instrucciones

Listening to the FM Radio

Tuning in a Station

Tune in radio stations automatically

1 Ensure that you have connected and fully
extended the FM antenna.
Press the FUNCTION button to select the TUNER
2
source.
3 Press and hold the
digital moved), then release the button, the
frequency changes down or up automatically
until a station is found.
4 Repeat steps 2-3 to tune to more stations.
Tune in radio stations manually

Press the ,

H/G
you find the station you want.

Presetting Stations

You can preset up to 20 FM stations.
Program radio stations automatically

Press and hold the M/Clock button until
"AUTO" appear, unit will search the stations
and program radio station automatically.
All available stations are programmed in the
order of waveband reception strength.
- The first programed radio station is played
automatically.
Program radio stations manually

1 Tune in the desired station, then press
button.
2 Press , ,
 
H/G
number.
/BT button again to store the
3 Press
BF
station.
4 Repeat above steps 1 to 3 for each station
you want to store in memory with a preset
number.
Note:
- If the system is unplugged or if a power failure
occurs, the preset stations will not be erased.

Tune to a preset radio station

Press M/Clock button twice, the press
buttons to select the preset radio station. Press
/BT button to play the preset station, or wait
BF
for seconds, the preset radio station is played
automatically.
, , buttons(till the
 
H/G
, buttons repeatedly until

BF
buttons to select the preset
,

H/G

Troubleshooting

To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
- Ensure that the AC cord of the apparatus is
connected properly.
- Ensure that there is power at the AC outlet.
- Press standby button to turn the unit on.
Remote control does not work
- Before you press any function button, first
select the correct source.
- Reduce the distance between the remote
control and the unit.
- Insert the battery with its polarities (+/-) aligned
as indicated.
- Replace the battery.
- Aim the remote control directly at the ensor
on the front of the unit.
Poor radio reception
- Increase the distance between the unit and
your TV or VCR.
- Fully extend the FM antenna.
- Connect an outdoor FM antenna instead.
Clock setting erased
/BT
- Power has been interrupted or the power cord
has been disconnected.
- Reset the clock.
Using iPhone to play music
- While the iPhone is playing the music throught
the docking, there may be a chance that the
iPhone may not be under a good receiption
mode to get the incoming call signal.
No Response From the Unit
- Disconnect and reconnect the AC power plug,
then turn on the unit again.
,

English 7