LaCie LaCinema Guía De Instalación Rápida página 6

Tabla de contenido

Publicidad

setup steps
Step 1: Install storage.
You must install a hard drive, where you will store your fi les. You have two choices: Plug in an
external USB hard drive OR install an internal hard drive.
Note: The LaCinema Classic Bridge is compatible only with disks formatted in FAT32. If you attempt to
install a disk formatted in NTFS or HFS+, fi les will not be available when the drive is connected to the
television. Refer to the User Manual for formatting information. Windows users should use the Formatter
Utility included on the CD-ROM, which will allow them to format their drive in one large FAT32 partition.
Option A: Plug in an external USB hard drive.
1. Connect your USB hard drive's power cord (if
applicable) and turn it on (if applicable).
2. Connect the USB cable from the USB hard drive to
the front USB port on the LaCinema Classic Bridge.
Option B: Install an internal hard drive.
A. Drive Installation.
Note: Install only a 3.5" SATA hard disk (5400rpm drives are strongly recommended). Check lacie.com
for a list of compatible drives. LaCie cannot guarantee that drives not on this list will be compatible
with the LaCinema Classic Bridge.
1. Turn the drive over so the rubber feet are
pointing up.
2. Open the casing by wedging the included case
opening tool into the seam between the bottom
plate and the top shell and gently pry them apart.
2 2
2

Publicidad

Tabla de contenido
loading

Tabla de contenido