Comfort Contego is not to be used as a substitute to the hearing aids and should be used in
accordance with the specifications and recommendations provided by your physician.
NOTE! Max output > 130 dB SPL. Could be very dangerous for your hearing.
It is recommended that customers keep the volume control in the lowest
position, when turning on the device.
Comfort Audio is not liable for damages arising from usage of the equipment not in accordance with
the instructions provided by Comfort Audio. Comfort Audio shall not be liable for performance prob-
lems and/or damages caused in any way by customer's modification of any part of the equipment.
Industry Canada, Operation is subject to the following two conditions:
(1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Federal Communications Commission Statement, This device complies with part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
WARNING!
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
--
Reorient or relocate the receiving antenna.
--
Increase the separation between the equipment and receiver.
--
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--
Consult the dealer or an experienced radio/TV technician for help.
2