Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MODEL: PMPCN
SAVE THESE INSTRUCTIONS
LOADING TOOL
Do not load the tool with fasteners when any one of
●
the operating controls is activated.
Never place a hand or any part of body in fastener
●
discharge area of tool.
Never point tool at anyone.
●
WARNING:
!
The warnings and precautions discussed above
cannot cover all possible conditions and
situations that may occur. It must be
understood by the user that common sense and
caution are factors which cannot be built into
this product, but must be supplied by the user.
UNPACKING
This tool has been shipped completely assembled.
●
Carefully remove the tool and any accessories from
●
the box.
Inspect the tool carefully to make sure no breakage
●
or damage occurred during shipping.
●
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
tool.
If any parts are damaged or missing, please call
●
1-888-669-5672.
08
HTTP://WWW FREEMANTOOLS COM
.
WARNING:
!
If any parts are missing do not operate this tool until
the missing parts are replaced. Failure to do so could
result in possible serious personal injury.
WARNING:
!
Do not attempt to modify this tool or create
accessories not recommended for use with this tool.
Any such alteration or modification is misuse and
could result in hazardous condition leading to
possible serious personal injury.
FEATURES
SPECIFICATIONS
AIR INLET:
1/4 inch NPT
WEIGHT:
1.38 lb
100 psi
MAXIMUM PRESSURE:
PRESSURE RANGE:
80 psi 100 psi
–
PIN SIZE RANGE: (Refer to the cleats drawing)
L Cleats
L Cleats
T Cleats
(18Ga.)
(16Ga.)
(16Ga.)
32 m
32 m
m
m
1-1/ 4"
1-1/ 4"
38mm
38mm
1-1/ 2"
1-1/ 2"
38 m
38mm
m
1-1/ 2"
1-1/ 2"
38mm
38mm
1-1/ 2"
1-1/ 2"
45mm
45mm
1-3/ 4"
1-3/ 4"
45mm
45 m
m
1-3/ 4"
1-3/ 4"
45 m
45 m
m
m
1-3/ 4"
1-3/ 4"
50 m
50mm
m
2"
2"
50 m
50mm
m
2"
2"
MIN. FLOOR THICKNESS: 5/16 (8mm)
"
.
1-888-669-5672
MODEL: PMPCN
OPERATION
LUBRICATION
This tool requires lubrications before using the tool for the first
time and before each use. If an inline oiler is used, manual
lubrication through the air inlet is not required on a daily basis.
⒈
Disconnect the air supply from the tool to add lubricant.
2.
Turn the tool so the air inlet is facing up. Place 2-3 drops of
pneumatic fastening tool oil into air inlet. Do not use
detergent oils, oil additives, or air-tool oils. Do not use
detergent oil or additives as these lubricants will cause
accelerated wear to the seals and bumpers in the tool,
resulting in poor tool performance and frequent tool
maintenance.
.
HTTP://WWW FREEMANTOOLS COM
3.
After adding oil, run too briefly. Wipe off any excess oil
from the cap exhaust.
CAUTION:
The work surface can become damaged by
excessive lubrication. Proper lubrication is the
owner's responsibility. Failure to lubricate the tool
properly will dramatically shorten the life of the
tool and void your warranty.
.
1-888-669-5672
09
Publicidad
Tabla de contenido
