Braun 7 Serie Manual Del Usuario página 8

high high
low low
8
If the station selects one of the required cleaning
programs, it will not start unless you press
the «clean & dry» button
results, we recommend cleaning after each
shave.
While cleaning is in progress, the respective
cleaning program indicator will blink. Each
cleaning program consists of several cycles,
where cleaning fl uid is fl ushed through the
shaver head and a heat drying process dries
the shaver. Depending on the program selected
the total cleaning time will range from 32 to
43 minutes.
The cleaning programs should not be
interrupted. Please note that while the shaver is
drying, the shaving head may be hot and wet.
When the program is fi nished, the blue «clean»
clean clean
indicator will light up. Your shaver is now clean
and ready for use.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators
of the Clean&Renew station and the shaver
display turn off.
Shaver display
The shaver display
of the battery. During charging or when using the
shaver, the respective green charge status will
blink. When the battery is fully charged the green
charge status will light up continuously, provided
the shaver is switched on or connected to an
electrical outlet.
Low charge indicator:
The red «low» charge indicator blinks to
indicate that the charge has dropped below
20%, provided the shaver is switched on.
The remaining battery capacity is suffi cient
for 2 to 3 shaves.
Charging information
• A full charge provides up to 50 minutes
of cordless shaving time. This may vary
according to your beard growth.
• The best environmental temperature for
charging is between 41 °F to 95 °F / 5 °C to
35 °C. Do not expose the shaver to
temperatures higher than 122 °F / 50 °C for
extended periods of time.
4
. For best shaving
z
shows the charge status