Installation; Appropriate Installation Location; Removing Packaging Reinforcement - Grundig GWN 39230 R Manual Del Usuario

Installation

Refer to the nearest Authorised
Service Agent for installation of the
product. To make the product ready
for use, review the information in
the user manual and make sure
that the electricity, tap water supply
and water drainage systems are
appropriate before calling the
Authorized Service Agent. If they
are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location
and electrical, tap water and
waste water installations
at the place of installation
is under customer's
responsibility.
B
WARNING: Installation and
electrical connections of the
product must be carried out
by the Authorized Service
Agent. Manufacturer
shall not be held liable for
damages that may arise
from procedures carried out
by unauthorized persons.
A
WARNING: Prior to
installation, visually check
if the product has any
defects on it. If so, do not
have it installed. Damaged
products cause risks for
your safety.
C
Make sure that the water
inlet and discharge hoses
as well as the power cable
are not folded, pinched or
crushed while pushing the
product into its place after
installation or cleaning
procedures.
56

Appropriate installation location

• Place the machine on a rigid floor.
Do not place it on a long pile rug
or similar surfaces.
• Total weight of the washing
machine and the dryer -with full
load- when they are placed on top
of each other reaches to approx.
180 kilograms. Place the product
on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the
power cable.
• Do not install the product at
places where temperature may
fall below 0ºC.
• Leaving a gap at the sides of the
machine is suggested to reduce
vibration and noise
• Do not place heat sources such
as Hobs, Irons, Ovens, etc. on the
washing machine and do not use
them on the product.
Removing packaging
reinforcement
Tilt the machine backwards to
remove the packaging reinforcement.
Remove the packaging reinforcement
by pulling the ribbon.