First Ribbon Installation - Sagem Photo Easy 260 Manual Del Usuario

All manuals and user guides at all-guides.com
Liasse AZUR_GB.book Page 7 Lundi, 23. mai 2005 11:31 11
F
IRST RIBBON INSTALLATION
Remark: use manufacturer consumables only. These are specially designed to provide
optimum print quality (Refer to paragraph Replacement of consumables,
page 28).
Remark: smart card validation is not necessary for the use of consumables supplied with the
printer (nature of supplies dependent on the model).
Switch on the printer. Wait 10 seconds for the printhead to lift, then:
1. Open the external flap located on the right-hand side of the printer.
2. Remove the protective foam.
3. Take the new ribbon out of its packaging and make sure that the film
is stretched after removing the card (A).
4. Install the ribbon in the position shown in the illustration below.
5. Insert the ribbon so that it is firmly seated in its housing. The locking
catch must be closed after insertion.
6. Close the external flap.
Warning:
never touch the film cartridge with your fingers. Make sure the cartridge is
completely inserted into the printer. Check that the green locking lever is correctly
lowered.
Remark: in the event of any difficulty, check that there are no foreign objects in the film
cartridge compartment.
A
6
- 7 -