Klarfit Bogera X Manual De Instrucciones página 19

ASSEMBLY
• Set the folded machine in vertical position on the floor.
• Lift up the Front Stabilizer (2) to open up the Rear Upright Pipe (1),
Insert the Locking Pin (41) into the joint welded on the middle part of
the Rear Upright Pipe (1) as show on drawing (A).
• Fit the Rear Ground Pipe (9) to the Rear Upright Pipe (1) with two
Carriage Bolts (13), At Washers (18) and Cap Nuts (25).
• Unfold the Pedals (33). Connect the Handle Joint (3) with the Rear
Upright Pipe (1) by Adjustment Knob (37) as shown on drawing (B).
1
EN
19