Product Familiarisation; Before Use; Intended Use; Unpacking Your Tool - Silverline 124799 Traducción Del Manual Original

GB

Product Familiarisation

1 Parallel Guide
2 Depth Stop Adjuster
3 Depth Stop
4 Brush Access Cover
5 Variable Speed Dial
6 Guide Rod Locking Knob
7 Spindle Lock Button
8 Collet Nut
9 Turret Stop
10 Guide Rod
11 Depth Stop Lock
12 Fine Adjustment Knob
13 Plunge Lock Lever
14 Dust Extraction Port
15 Base Plate
16 Safety Button
17 On/Off Switch
18 Brush Access Cover
19 Measurement Bar
20 Collets
21 Guide Bush Plate
22 Roller Guide
23 Circle Guide
Accessories (not shown):
• 1 x collet spanner
• 5 x router bits
• 1 x hex key
• 2 x spare brushes
• 1 x additional guide bush plate

Intended Use

Hand-held plunge router for use with 1/2", 1/4", 8mm, 10mm, and 12mm shank router bits
(depending on the collet installed). Used for cutting profiles, grooves, edges and elongated holes
in natural and composite wood. Also used with guide bushes and templates for cutting of shapes,
following patterns, as well as for stationary installation in suitable router table systems.

Unpacking Your Tool

• Carefully unpack and inspect your tool. Familiarise yourself with all its features and functions.
Ensure that all parts of the tool are present and in good condition. If any parts are missing or
damaged, have such parts replaced before attempting to use this tool.
6

Before Use

WARNING: ALWAYS ensure that the machine is disconnected from the power supply before fitting
or removing attachments, or altering any machine settings
Installing dust extraction port
• Attach the Dust Extraction Port (14) to the Base Plate (15) using the nuts and bolts supplied
• Dust from certain materials can be toxic. Attach a dust extraction system to the Dust Extraction
Port (14) whenever possible, before using the router
Installing a router bit
Note: Wear protective gloves when inserting and removing router bits due to the sharp edges of
the cutters.
• Press in the Spindle Lock Button (7) and rotate the spindle so that the lock engages
• The Collet Nut (8) can then be slackened (it may be necessary to use the supplied spanner)
• Ensure that the correct size of collet is installed. If it is necessary to change the collet, unscrew the
Collet Nut completely, change the collet and replace the nut
• Insert the router bit into the collet, ensuring that at least 20mm, or half of the shaft (whichever is
greater) is inserted into the collet
• The Collet Nut can then be tightened using the Spanner supplied.
WARNING: DO NOT over tighten the collet nut, as this could cause damage to the collet or the
spindle lock.
Removing a router bit
• Press in the Spindle Lock Button (7) and loosen the Collet Nut (8).
The router bit should now be loose and can be removed
• If the router bit does not release from the collet, gently tap the collet nut to release.
WARNING: ALWAYS keep the collet, collet nut, spindle threads and router bit shank clean to ensure
a reliable and secure fitting.
Fitting the parallel guide
• When grooving, or chamfering, use of the Parallel Guide (1) will help to ensure that accurate
cuts are made