Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
According to Waste Electrical and
Electronic Equipment directive (WEEE),
these ones must be collected and arranged
separately. If you have to throw them out,
please, do not use the usual rubbish. Please,
contact your distributor for free recycling.
Attention! Be careful.
1. Do not switch on the pump while disconnected from water source. The pressure created while
switched on and disconnected could lead to serious injury.
2. Always follow safety precautions: Respect general safety instructions; prevent water from flowing
inside the pump, use protective footwear and eyewear.
3. Respect electrical safety instructions: maintenance and inspections must be carried out while
the pump is disconnected from the power supply. Do not stretch the power cable and replace if
damaged. Keep all electric parts dry.
4. Check that pressure hoses are free from obstruction and damage. If necessary, replace only with
original spare parts.
5. Always check that the motor has adequate ventilation through the chassis.
6. If you don't use the pump for a long time, and/or in low temperature countries, put a small
amount of anti-freeze solution inside the pump. This will extend the gasket working life. Before
restarting the pump, if necessary turn the shaft (via the hole on the chassis) to release the valves.
7. The pump is made for transplant works, repairs and water installations. The liquids that can be
used should have maximum1.5mPas viscosity and use water solutions between 7 and 12 pH.
Capacity
Engine
Pressure
Hose diameter
Weight
SAFETY INSTRUCTIONS
TECHNICAL CHARACTERISTICS
3L/min
250W - (110-130V/50-60Hz)
60=860Psi
1/4"
11 Kgs.
ENGLISH
5
Publicidad
Tabla de contenido
