Applied Standards - AEG BMG 4922 Manual De Instrucciones

В интернет-магазине www.clatronic-shop.com.ua
Troubleshooting
Malfunction
The battery symbol
is indicated on the
display.
A conspicuous abnormal
result is indicated.
"ERR" is indicated on
the display.
The device does not
react to any but-
ton press.
All manuals and user guides at all-guides.com
Тонометр AEG BMG 4922
Cause Remedy
• The batteries are • Install new
drained. batteries
• Did you use 1.2V • The device only
batteries? works with 1.5V
batteries
• The blood pressure • Fasten the cuff
cuff is improperly with more care
placed or is in the
wrong position.
• You moved the • Stay as relaxed
arm or the device. as possible and
do not move
anything on the
device.
• Your heartbeat is • If your heartbeat
irregular. is strongly
irregular, you
cannot take
measurements
with this device.
• Did you talk • Avoid all infl u-
during the ences that cause
measurement? unrest.
Were you nervous
or somewhat
excited?
• There was a • Pay attention to
malfunction dur- our notes in the
ing the infl ation portions of the
of the cuff or in text for the blood
the remainder of pressure cuff and
the process. measurement.
• The blood pressure • Repeat the
cuff is insuf- measurement
fi ciently infl ated.
• There was a • Fasten the cuff
malfunction dur- again
ing the infl ation • Sit quietly
of the cuff or in
the remainder of
the process.
• The batteries are • Replace the
drained. batteries
• Malfunction of • Remove the
the electronic batteries and
control re-insert them
again.
• Take the device
to a dealer or to
service.
Care
Attention:
• Do not immerse the device in water.
• The blood pressure measuring device may not get
wet.
• Do not use any harsh cleaners or solvents.
• Wipe off the blood pressure cuff with a wet cloth. For
persistent spots, you can apply a gentle soap solution.
• Dry off the blood pressure cuff after cleaning it.
• Please, wipe the blood pressure measuring device with
a dry cloth.

Applied Standards

The CE marking CE 0123 of the measuring device
corresponds to EU Directive 93/42/EEC (Medical Device
Directive). The following standards apply for the design
and/or production of the product:
EN 60601-1: Medical electrical equipment Electromagnetic
compatibility.
EN 1060-1: Non-invasive blood pressure meter
EN 1060-3: Non-invasive blood pressure meter
Amendments of the technical specifi cation without
information are reserved for updating reasons.
Representative for Europe:
ShangHai International Holding Corporation GmbH
Eiff estr. 80
20537 Hamburg
Deutschland
Telephone: 0049-40-2513175
Fax: 0049-40-255726
English
51