Device Overview - Canyon CND-GPW5 Manual De Instrucciones

Device overview

A Command buttons
B 8 D Direction pad
C/D Left analog stick/Right analog stick
E Home button (back to menu, wake up, switch off.)
F/G Share ( share your gameplay online)/ Option (set option menu)
H/I Turbo button/ Turbo LED indicator
J/K R1/L1 buttons/triggers
L/M R2/L2 buttons/triggers
N Smart light bar (7 available colors)
P Remapping/macro buttons M1-4 / default settings are command buttons
Q Touch panel
Turbo function
1. Hold the key to which you want to apply the turbo function while not releasing it,
and then press the turbo button once.
2. To cancel this function, hold the key to which you applied the turbo function and do
not release and then press the turbo key once.
3. If turbo function is active, Turbo LED will blink.
Programming M1-M4 buttons
M1-M4 are the remapping buttons and they can remap up to a maximum of 10
buttons. Their default settings are the same as for the command buttons.
Mode A Remapping:
1) Press M(1-4) first and hold it without releasing and then press the <Share> button
until the Turbo LED light is on. Gamepad is now in 'setting' status and you may release
the former 2 buttons.
2) Hold the button to which you want to set the function, eg. L1, R3 etc, press M (1-4)
again to confirm the setting and the Turbo LED light will then switch off to show the
setting is successfully completed.
3) M (1-4) after setting will be stored in the memory. You can change the setting for each
button by repeating the above steps. If you want to clear the memory and remove the
setting then press M(1-4)+Share+M(1-4).
Mode B Macro:
1) Press M(1-4) first and hold it without releasing and then press the <Option> button
until the Turbo LED light is on. Gamepad is now in 'setting' status and you may release
the former 2 buttons.
2) Press the buttons one by one to which you want to set the macro function, eg. L1 +
R1 +L2 etc, press M (1-4) again to confirm the setting and the Turbo LED light will then
switch off to show the setting is successfully completed.
3) The sequence of actions depends on the order of the selected buttons. If you press
M(1-4), then it will activate button L1 first, then R1, then L2, in sequence one by one in
the order you originally selected.
4) M (1-4) after setting will be stored in the memory. You can change the setting for each
button by repeating the above steps. If you want to clear the memory and remove the
setting then press M(1-4)+Option+M(1-4).