Axis T92E Housing Serie Manual Del Usuario página 10

Page 10
I/O cable
Bracket adapter screw (4x)
Bracket adjustment screw
5. Install the cable cover and tighten the cable cover screws.
6. Connect the camera to the network. Depending on the type of housing, connect the network
cable to the network connector on the camera or the housing, see illustrations on page 9 and
page 10.
7. If applicable, check that the Status LEDs indicate the correct conditions. See table on page 12
for further details. Note that the Status LED can be configured to be unlit during normal
operation.
8. Loosen the bracket adjustment screw to aim the camera to the point of interest and focus the
camera according to the instructions in the Installation Guide provided with the camera.
9. Take the top cover and attach the safety wire to the tab on the bottom cover.
Example image: AXIS P1343 Network Camera and AXIS T92E20 Outdoor Housing
Alarm output
AXIS T92E05/T92E20 User's Guide
Network cables
Cable holes
Bottom cover
Cable cover
Cable cover screw (2x)
Wall bracket
Bottom cover
Network connector (PoE OUT)
Cable holes
Network connector (PoE IN)
LED indicator
Cold Startup Delay switch
(see text below)
Example image: AXIS T92E20 Outdoor Housing