Install The Wall Bracket; Install The Camera On The Bracket - Axis T92E Housing Serie Manual Del Usuario

AXIS T92E05/T92E20 User's Guide
4. If applicable, connect the network cable and the I/O cable, which are pre-installed in the
outdoor housing, to the camera, see illustration on page 10 and table on page 8.
5. Fit the holder on the bottom cover and adjust its position. Allow just enough distance,
approximately 5–10 mm (0.2–0.4 in.), between the camera lens and the front end of the plastic
inner housing to fit the top cover without the window scratching the lens.
6. Tighten the screws.
7. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.
8. If applicable, set the Cold Startup Delay switch to the correct position, see table on page 8 and
Cold Startup Delay Switch,

Install the wall bracket

1. Use the supplied drill template to prepare a wall or pole for installation of the wall bracket.
2. Route the network cable through the wall bracket according to the wall bracket illustration in
Hardware overview,
camera.
3. Install the wall bracket on a wall or pole and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).

Install the camera on the bracket

1. Loosen the cable cover screws and remove the cable cover from the bottom cover.
2. Install the camera with the bottom cover on the bracket and tighten the bracket adapter
screws.
3. Remove the gasket from one of the holes in the bottom cover, see illustrations on page 6 and
page 10.
4. Route the cable through the hole and attach the cable gasket to the hole.
Example image: AXIS P1343 Network Camera and AXIS T92E05 Protective Housing
on page 11.
on page 6. Leave approximately 30 cm (11.8") of cable for connecting the
Network cable (route
through wall bracket)
Page 9