Installation instructions
1.
Checking the installation cavity
m
CAUTION
To ensure a safe, trouble-free installation and an optimum
overall view of the subsequent furniture front, thoroughly
check that the installation cavity complies with the
installation requirements.
Before starting the installation, check that the installation
cavity complies with all requirements for a safe and trouble-
free installation.
Check the base.
Follow the instructions in the section on "Installation
location" on page 7.
Check the dimensions of the cavity.
Check that the cavity is square.
Check location of the socket.
Also follow the instructions in the section on
"Connecting the power" on page 8 and in the section on
"Installation dimensions" on page 9.
Check location of the water connection (only for
appliances with ice maker).
Also follow the instructions in the section on
"Connecting the water" on page 8.
Check attachment of the adjacent furniture/fixtures. All
furniture parts in the vicinity of the appliance must be
connected securely to the wall.
Check that adjacent furniture/fixtures do not collide
(door opening angle)."
12
2.
Transport of the appliance
m
m
The appliance is very heavy. Be careful, otherwise people
who are helping may be injured or the appliance may be
damaged.
Transport the appliance to a suitable installation location
with suitable means of transportation (trolley, lifting truck
or hand-driven truck).
Secure the appliance during transportation to prevent it
from overturning.
The appliance is 84" (2134 mm) tall. If the appliance cannot
be transported in an upright position due to the structural
conditions, the appliance can be transported horizontally.
When erecting the appliance, observe the required minimum
height at the installation location according to the following
table:
Erection via appliance rear
86" / 2185 mm
CAUTION
Erection via appliance
side panel
Never put the appliance
up via its side!
m