Publicidad
Idiomas disponibles
Idiomas disponibles
FIlleR PANel Assembly (FOR Use WItH style
seleCtIONs GAs FIRePlACe ONly)
If you are installing a Style Selections Gas Fireplace in this
mantel, you will need to follow the instructions in this section.
If you are not installing a Style Selections Gas Fireplace, go
to Mantel Top Assembly and discard items #14 and #15.
1. Place Style Selections filler panel (#14) in position in front
of mantel with trim strip to outside covering joint between
filler panel and mantel (see Figure 4).
2. With one person holding filler panel in place, attach filler
assembly (#14) to bottom of header mantel side using 3
filler panel blocks #15 and six 1
(see Figure 4). Do not tighten screws.
1
/
" Screw with Washer
1
4
Filler Panel (#14)
Figure 4 - attaching Style Selections Filler panel
121341-01A
/
" screws with washers
1
4
Filler Panel (#14)
Back View
www.desatech.com
mANtel tOP Assembly
Place mantel top (#7) on mantel assembly. Align back of top
with back of sides. Using seven 1
place two in each mantel side assembly and three in the header
(see Figure 5). Make sure all pieces are aligned properly and
tighten all seven screws.
Washer
1
/
"
1
4
Screw
Mantel
Side
Assembly
Figure 5 - attaching mantel top
eleCtRIC FIRePlACe INstAllAtION
This mantel can be used with a 26" intermediate Fireplace.
Electric fireplaces install from the front of mantel. To install
electric fireplace see fireplace instruction manual.
/
" screws with washers,
1
4
Mantel Top (#7)
3
Publicidad
