Follow These Steps When Battery Is Installed In Vehicle - Forney 52755 Manual Del Propietário

FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE

A SPARK NEAR BATTERY MAY CAUSE BATTERY
EXPLOSION. TO REDUCE RISK
OF A SPARK NEAR BATTERY:
TO PREVENT SERIOUS INJURY: Wear ANSI-
approved splash-resistant safety goggles and
heavy-duty rubber work gloves whenever
connecting, disconnecting, or working near battery.
Battery acid can cause permanent blindness.
WARNING! Do not use Start setting to charge
batteries. Use to jump start only.
COLD BATTERIES: Begin charging at lowest rate,
increase rate as battery reaches normal temperature.
DO NOT CHARGE A FROZEN BATTERY
1. Unplug Charger/Starter.
2. Position AC and DC cables to reduce risk of
damage by hood, door, or moving engine part.
3. Stay clear of fan blades, belts, pulleys, and other
parts that can cause injury to persons.
4. Check polarity of battery posts. POSITIVE (POS,
P, +) battery post usually has larger diameter than
NEGATIVE (NEG, N,–) post.
5. Determine which battery post is grounded
(connected) to the chassis. If negative post is
grounded to chassis, see a. If positive post is
grounded to the chassis, see b.
a. For negative-grounded vehicle (as in most
vehicles):
• Connect POSITIVE (RED) clip from battery
Charger/Starter to POSITIVE (POS, P, +)
ungrounded post of battery.
• Connect NEGATIVE (BLACK) clip to vehicle
chassis or engine block away from battery.
Do not connect clip to carburetor, fuel lines,
or sheet-metal body parts. Connect to a
heavy gauge metal part of the frame or
engine block.
b. For positive-grounded vehicle:
• Connect NEGATIVE (BLACK) clip from battery
Charger/Starter to NEGATIVE (NEG, N,
–) ungrounded post of battery. Connect
POSITIVE (RED) clip to vehicle chassis or
engine block away from battery. Do not
connect clip to carburetor, fuel lines, or
sheet-metal body parts. Connect to a heavy
gauge metal part of the frame or engine
block.
6. Plug Charger/Starter into grounded 120V
receptacle.
7. Turn Power Switch on.
8. Press Function Select Button until desired function
lights up. Refer to Table B on page 6.
WARNING! Do not use 12V 200A Start function for
charging.
9. Press Start/Stop button to start function.
10. When finished, turn Power Switch off, unplug
power cord, remove clip from vehicle chassis, and
then remove clip from battery terminal.
11. After use clean, then store the charger indoors out
of children's reach.
WWW.FORNEYIND.COM 9