Altec EI-185 Manual De Instrucciones página 23

6.2 Last-digit Reading on the Display (Model EI185)
The last digit on the display can be eliminated. This can be done by the Jumper 3, located on the
display card, which will disable the operation of this digit when in the open position.
6.3 Display (Model EI185)
The display reading can be dampened. This is possible via Jumper 4, which will dampen the
reading when in the closed position and will keep the reading in a maximum time when opened.
6.4 Jumpers and Trimpots Positions
6.5 Interconnection of the Indicator with the Load Cells (Models EI-185 / EI-264)
See the interconnection scheme indicated for your load cell. Load cells manufactured with 350Ω
metallic strain gages in full-bridge (ALTEC) are interconnected as per scheme 1. Load cells manufactured
with 120Ω semiconductor strain gages in half-bridge (CMC) are interconnected as per scheme 2; if a
single cell is used, interconnect as per scheme 3.
SCHEME 1
red
white or transp.
black or green
www.altec.com.br
SCHEME 2
blue red
white
NOTE: The connector is removable
TENSION INDICATOR MODEL EI-185
SIGNAL TRANSMITTER MODEL EI-264
SCHEME 3
red
23