Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
14.7 Tracks
14.7.1 Tightening
With use, tracks tend to loosen. When operating with loose
tracks, they tend to slip over the driving wheel causing it to
jump its housing or to work in precarious situation, thus
damaging wear to the housing.
To check track tightness, proceed as follows:
a. Set the machine on a flat surface with compact ground,
better on an asphalt or stone pavement.
b. Lift the machine and set it on blocks or supports rated for
the weight of the machine so that the tracks are
approximately 100mm off the ground.
c. Measure the track midline vs. the horizontal line. The
reading must not be more than 10 - 15mm.
If the distance is greater, proceed as follows:
a. Use the tipping handle to tip the dump box and set it on
blocks or supports rated for the weight of the box.
b. Loosen the locknut A. Tighten bolt B until the correct
tightness is restored.
c. Secure bolt B by tightening locknut A thoroughly.
d. Return the dump box to its original position
WARNING
The adjustment of the chains affect the brakes. Please with great caution proceed as a chain spanned
loss of braking action results.
If the adjustment does not allow further adjustment more, the chain should be replaced.
e. Tilting bring back to the starting position.
14.7.2 Replacing tracks
Check the condition of the tracks periodically. If any track is cracked or frayed, it should be
replaced as soon as convenient.
WARNING
When removing and replacing the chain, make sure that you pinching your hands between the
wheel and the chain.
ZIPPER MASCHINEN GmbH
ZI-MD500HST
www.Zipper-Maschinen.at
MAINTENANCE
39
Publicidad
Tabla de contenido
