Stiga T8125 Manual Del Usario página 3

5. Rotate U-support #7 until you see the screw hole in the
slot of U-clip # 3. Slide U-support #7 side to side if
necessary.
Note: To aid in assembly you can use a cordless drill and
Phillips bit for Step 6 only. Wear safety glasses.
6. Insert screw #19 through slot in U-clip #3 and into U-
support #7. Thread it all the way into U-support #7
until it touches the back of the tube. There should be
about 3/8 inch of screw #19 left sticking out. Repeat
for U Leg #2.
If you want to see a video on how to insert Screw (#19) go to:
http://www.escaladesports.com/customer-service/videos.html
7. Attach hinge and brackets #6 and #4 to U-leg #2 as
shown in Figure 4. NOTE: Hinges are right hand
and left hand and must be attached as shown.
Left hand hinge #6 has the letter "L " stamped on it and
the right hand hinge has "R". Attach with screws #14,
plastic washers #21 and locknuts #16. Tighten nuts
until snug, but do not overtighten. Hinges must pivot.
See Figure 4.
Note: Slide U-support back and forth until you
see the hole if necessary.
3
U-Support
Wider
U-Leg
3
Figure 4
16
6
14
21
16
21
Left hand
6
14
hinge has "L"
stamped on it.
3
Figure 3
7
U-Support
19
2
U-Leg
19
14
4
21
16
21
2
16
This end will be the
middle of the table when
completely assembled.
14
4
Right hand
hinge has "R"
stamped on it.