Descargar Imprimir esta página

Far Tools TM 05 C Traduccion Del Manual De Instrucciones Originale página 3

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 4
EN
The angle grinder is designed for cutting and trimming, using the
suitable disks, steel and building materials (stone, brick, breeze-blocks,
reinforced concrete, etc.). It can also be fitted with accessories and used
for sanding and brushing.
There is a whole range of sizes for grinders, generally 115 mm to 230 mm in
diameter. The 115 mm - 125 mm models are generally used for carrying out small
jobs, because they are light and easy to use. The 230 mm models are used for much
heavier tasks.
The cutting capacity of the grinders depends, to a great extent, on the type of disk
used. There are disks for cutting metal, sheet metal, masonry (stone, breeze-block,
etc.)
The speed control, if your machine is fitted with one, makes trimming and sanding
work easier.
The soft start function, if your machine is fitted with it, makes it easier to start on the
piece to be ground more efficiently and with greater precision.
The trimming function can be used to remove burr that is left behind after cutting,
for example. You must use a disk that is appropriate to the material, and work at an
angle of around 25°, and move the tool back and forth constantly and smoothly.
The cutting function consist to work at an angle of 90° with an appropriate disk to
the material.
© FAR GROUP EUROPE
115030-Manual-D.indd 3
4/06/13 16:09:53

Publicidad

loading