Care And Cleaning; Troubleshooting - Black and Decker Cyclone BLC12600B Libro De Uso Y Cuidado

Care and Cleaning

This product contains no user serviceable parts. Refer service to qualified
service personnel.
CLEANING
1. Before cleaning, turn off and unplug the appliance.
2. To remove the jar, using both hands, grasp the handle with one and the base
of the jar with the other, turn slightly counterclockwise to unlock position and
lift up.
3. Remove jar base by turning it counterclockwise until loose.
4. Remove the gasket and the blade assembly.
Caution: Blades are sharp, handle carefully.
5. Remove lid and lid cap.
6. Wash removable parts by hand or in the dishwasher. Place the jar on the
bottom rack and the rest of the parts on the top rack only.
Helpful Tips:
• For quick cleanup, combine 1 cup hot water and a drop of liquid dish soap
in the blending jar.
• Cover and blend on CleAN for about 30 seconds.
• discard liquid and rinse thoroughly.
Important:
• do not place the jar parts in boiling liquids.
• do not immerse the base in liquid. Wipe the base with a damp cloth and dry
thoroughly.
• Remove stubborn spots by rubbing with a damp cloth and nonabrasive
cleaner.
Note: If liquids spill onto the base, wipe with a damp cloth and dry thoroughly.
do not use rough scouring pads or cleansers on parts or finish.
0

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Jar base bottom does A vacuum has been
not come off of jar. formed.
liquid is leaking Gasket is either missing
from bottom of jar. or not in place correctly.
Appliance does Appliance is not
not turn on. plugged in.
Mixture in blender Not enough liquid in
does not seem to mixture being blended
be blending. or too much ice.
Herbs or bread are Blending jar, food to be
sticking to sides of chopped and blade are
blender and not not dry.
getting chopped.
Jar separates from Jar was twisted when
jar base when being being removed from
removed from base of blender.
blender. liquid
spills onto counter.
SOLUTION
Place the jar on the
blender and turn
counterclockwise until
jar is released from the
jar base.
Check that jar is
assembled correctly.
Check that appliance
is plugged into
a working outlet.
Turn the blender off
and use a rubber
spatula to redistribute
the food; add some
liquid and PUlSe the
mixture to aid in the
blending process.
Always make sure that
the jar, the blade and
the food to be chopped
are dry.
When removing jar
from blender base,
simply lift up; do
not twist.