Troubleshooting; Service Centre; Environmental Concerns - Concept ZV2010 Manual Del Usuario

EN

TROUBLESHOOTING

If your humidifier does not work properly, check the following possible causes:
Problem
The humidifier does not work.
The power cord is not connected.
The indicator is on, but no mist
There is too much water in the
is coming out of the appliance.
Water level in the water tank is
Water is leaking from the water
No mist
The temperature of the device is
Deposit on the converter
Too much/too little water in the
Deposit on the converter
Weak mist output
Water is too cold
The water is not clean.
Hard water can deposit a certain
amount of white powder on the
converter. The white powder
White dust is formed on the
is decomposed by ultrasonic
furniture.
vibrations and blows into the air
along with the mist. White powder
in the air settles on the furniture.
Saturation of moisture.
Water accumulates outside the
humidifier or the surrounding
The device is not levelled and
area.
accumulates water.
60
Cause Remedy
Plug the power cord into the
socket.
Pour some water from the water
water tank. tank.
Fill the water tank with water.
too low.
Check that the water tank is in the
tank. correct position.
Place the device at a room
temperature for half an hour before
too low.
use.
Clean the converter.
Pour out water from the water
water tank tank/add water to the water tank.
Clean the converter.
Use water with a room
temperature.
Clean the water tank and pour
fresh, distilled or demineralized
water into it.
If the problem persists, use distilled
water. Do not forget to clean the
converter and the filter after a short
use.
Switch off the humidifier or set it to
a low mist level.
Unplug it and place it on a flat
surface. Aim the mist nozzle
away from objects. Place it on
a waterproof, flat surface at least
60 cm from the floor.
The mist has an unusual odour.
The device generates unusual
noise
The water tank lid cannot be
opened

SERVICE CENTRE

Extensive maintenance or repair, which requires access to internal parts of the product, has to be performed by
a qualified specialist or the service centre.

ENVIRONMENTAL CONCERNS

• Packaging materials and old appliances should be recycled.
• Packaging materials may be disposed of as sorted waste.
• Dispose the plastic bags made of polyethylene (PE) of as sorted waste.
Recycling of the appliance at the end of its lifespan:
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste electrical and electronic equipment - WEEE). The symbol
on the product or on its packaging indicates that this product may not be treated as household
waste. Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health, which could otherwise
be caused by inappropriate waste handling of this product. The disposal of such material has to be
done according to the recycling regulations. For more detailed information about recycling of this
product, please contact your local council, your household waste disposal service or the shop where
you purchased the appliance.
The product meets all the necessary requirements of the EU directives applicable to the specific
product.
Changes in text, design, and technical specifications are subject to change without prior notice and we reserve the
right to change them.
ZV2010 ZV2010
Open the water tank and place
The appliance is new. it for 12 hours in a dark and cool
Clean the water tank and pour
Water in the water tank is dirty or it
fresh, distilled or demineralized
has been there for too long.
water into it.
The noise in the water tank is
Fill the water tank.
caused by a low water content.
The appliance is not placed on a flat Move the appliance to a stable, flat
surface.
The lid has been tightened too Apply a small amount of liquid
much. soap to the seal to open.
EN
place.
surface.
61