Danby DBC128BLS Guía A Utilizar Y A Cuidar Del Proprietario página 4

Centro de bebidas autónomo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS (cont'd)
DOOR REVERSAL
INSTRUCTIONS
1) Unplug the unit from the electrical outlet (if
connected) and lay it on its back.
2) Remove the screws from the lower hinge assembly
as shown in Figure 1.
3) Pull the door downward to remove it from the
Beverage Center.
4) Remove the cap from the top left side of the door
(Fig. 3) and reinstall it on the top right side.
5) Remove the three (3) screws supporting the top
hinge (Fig. 4).
6) Remove the plastic caps from the left side of the
frame (Fig. 2) and reinstall them on the right side of
the frame (the previous hinge location).
Fig. 3
PLASTIC CAPS
Fig. 2
DOOR PLUG
(2)
7) Install the upper hinge assembly on the left side of
the frame.
8) Carefully reposition the door into the upper hinge
assembly, then onto the unit.
9) While the door remains closed, install the lower
hinge assembly.
10) Close the door and return the unit into its upright
position (wait 60 minutes before reconnecting power
to the Beverage Center); verify the door alignment
and proper seal against the unit.
Fig. 4
Fig. 1
3
U
H
PPER
INGE
LOWER HINGE
ASSEMBLY AND DOOR
SUPPORT BRACKET

Publicidad

Tabla de contenido
loading

Tabla de contenido