Danby DBC128BLS Guía A Utilizar Y A Cuidar Del Proprietario página 6

Centro de bebidas autónomo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS (cont'd)
INTERIOR
The operation of the interior light can be "manually" controlled as well as controlled with the
LIGHT
opening or closing of the door.
To manually operate the light; depress the interior
light toggle switch situated on the left side of the
interior light housing located on the ceiling of inner
unit (as shown in Figure C); this will allow the
interior light to remain on while the door is closed.
Defrosting:
Your beverage center is designed with an "Auto-
Cycle" defrost system.
What is Auto Cycle defrost?
The refrigerated surfaces of the fresh food
compartment defrost automatically during the "off"
cycle of the cold control (thermostat). Defrost water
from the fresh food compartment is disposed of
CAN
The *maximum capacity of the DBC128 is 128 (355ml) cans.
STORAGE
*When stocked as per instructions below.
In order to achieve the maximum storage capacity of 128 cans, it will be
necessary to position the cans in the following manner;
• Twenty-two (22) cans upright on the top shelf surrounding the interior light.
• Twenty-five (25) cans upright on each of the center 3 shelves.
• Thirty-two (32) cans laying on the bottom of the cabinet (as shown in Fig D). This
will allow for a total storage capacity of one-hundred and twenty-eight (128) 355 ml
cans.
IMPORTANT! Do not cover shelves with aluminum
SHELF
foil or any other material that will prevent adequate air
INSTRUCTIONS
circulation within the cabinet.
• To remove a shelf from its locked position, tilt the rear portion of the shelf up
and pull outward.
• To re-install, ensure the shelf is resting securely on the support brackets and
push shelf inward until it locks into place.
Please note: Each of the top three staggered shelves have a color coded marker
on the rear rail. In order to stock the beverage cans as per the above "Can
Storage" instructions, it will be necessary to install the shelves as shown in
Figure E. The correct positioning of shelves should allow you to easily place a
standard 355 ml beverage can upright between each shelf.
automatically, by means of being channeled onto a
drip tray located on the compressor. Heat transfer
from the compressor causes thedefrost water to
evaporate.
I
NTERIOR LIGHT
TOGGLE SWITCH
5
Fig. C
Fig. D
Red
Fig. E
Yellow
Green
Important! The bottom flat shelf
in the cabinet is not secured in
place (locked). Do not attempt to
pull on shelf when it is stocked.

Publicidad

Tabla de contenido
loading

Tabla de contenido