Connecting The Handset Lifter To The Base Station; Connecting The Handset Lifter To The Telephone - Sennheiser HSL 10 Instrucciones De Funcionamiento

way, that it is placed directly on the loudspeaker.
Always make sure not to cover the microphone inlet
2c
Connect the jack plug of the microphone to the microphone socket
3
1

Connecting the handset lifter to the base station

Connect the ACCESSORIES socket on the DW 800 or BW 900 base station with the handset
lifter's modular socket
times, if the base station is connected to power.
Test the HSL 10 by pressing the hook button on the base station. The lever should move.

Connecting the handset lifter to the telephone

Note!
You can use the adhesive mounting tape only once. Therefore, we recommend not to remove
the backing from the tape before you have determined the correct attachment position as
follows:
With the handset put on, hold the HSL 10 handset lifter between the telephone and the
handset, as close to the handset loudspeaker as possible.
In order to check whether the HSL 10 is in the correct position or not, press the hook button
on your mobile device or the base station, respectively. The position is correct, if the
lifting pad raises only the loudspeaker side of the handset and you can hear a dial tone.
Remove the backing from the adhesive tape and affix the HSL 10 with the adhesive tape.
using the connection cable provided. The LED
with the double-sided adhesive tape.
.
lights up blue five
5