C6.2 Changing The Detergent/Rinse-Aid Type; D1 Starting; User Instructions; Control Panel - Insinger CADET CDT-1 Instalacion, Uso Y Mantenimiento

C6.2 Changing the detergent/rinse-aid type

If changing to a different detergent/rinse-aid type
(even one by the same manufacturer), you must rinse
the suction and pressure hoses with fresh water before
connecting the new detergent/rinse-aid container.
D
Our appliances have been studied and optimized to give the highest performance. This appliance must be used exclusi-
vely for the purpose for which it has been designed, i.e. for washing dishes with water and specific detergents. Any other
use will be considered "improper use" and will void the warranty and manufacturer liability.
This appliance will not carry out the rinse cycle should there be no supply water; it stops all functions and an error mes-
sage "A1" will be displayed (also see "Warning Messages Displayed On The Control Panel").
• Carry out a couple of cycles without dishes to flush out any industrial grease which have remained in the tank
and piping.
• Avoid washing decorated dishes.
• Do not allow silverware to come into contact with other metals.
• Do not allow food to dry on the dishes.
• Remove large food scraps from the dishes to prevent clogging the filters.
• Pre-wash the dishes by spraying them with cold or lukewarm water, do not use any detergent.
• Use automatic dispensers for the detergent.
• If there is no automatic dispenser, pour a non-foaming detergent into the tank when the water has reached the
washing temperature.
LEGEND:
A = ON/OFF
B = De-lime cycle
C = Drain/self-cleaning cycle
D = Display
The temperature shown on the display is that of the booster if the indicator light "F" is on or of the tank if the light "E" is
on. The tank temperature is displayed during the wash cycle and the booster temperature during the rinse cycle.
D1 STARTING
• Open the water supply shutoff valve.
• Switch unit on at the main circuit breaker.
• Open the door and check that all the components are
in their correct position.
• Close the door and press ON/OFF "A" button.

USER INSTRUCTIONS

TIPS

CONTROL PANEL

A B C D
Figure 14
Otherwise, the mixing of different types of deter-
gent/rinse-aid will cause crystallisation, which may result
in a breakdown of the dosing pump. Failure to observe
this condition will invalidate the warranty and product lia-
bility.
E F G H L
DETERGENT PRIMING
RINSE AID PRIMING
E = "Tank temperature" indicator light
F = "Booster temperature" indicator light
G = Wash cycle 1
H = Wash cycle 2
L = Wash cycle 3
The indicator light of the ON/OFF button "A" (Figure 14)
comes on, indicating that the dishwasher is powered and
that water is being introduced and heated.
13