Troubleshooting - Insinger CADET CDT-1 Instalacion, Uso Y Mantenimiento

Falling from The operator intervenes on the
above machine using unsuitable systems
to access the upper part (e.g. rung
ladders, or climbs on it).
Tipping of During maintenance on the machine
loads or the
machine with the use of unsuitable
accessories or lifting systems or with
load unbalanced.
Chemical Contact with chemical substances
(e.g. detergent, rinse aid, scale
remover, etc.) without taking ade-
quate safety precautions. Therefore
always refer to the safety cards and
labels on the products used.
E
DISHWASHER DOES NOT WASH
WELL
GLASSES AND DISHES ARE NOT
DRIED PROPERLY
CONDENSATION ON GLASSES
STAINS ON THE GLASSES
EXCESSIVE FOAM IN THE TANK
SMEARS OR SPOTS ON THE
GLASSES
THE WASH OR RINSE ARMS
TURN SLOWLY
18
packing containing the

TROUBLESHOOTING

1. Check if the suction filter is dirty, if so clean it thoroughly.
2. Check if the wash jets are clogged by solid food particles.
3. Check that the initial amount of detergent or subsequent additions are cor-
rect.
4. The selected wash cycle is too short. Repeat the cycle.
5. Check that the tank temperature is between 131°F [50°C] and 154°F
[68°C.]
6. Check that the dishes are stacked correctly in the racks.
1. To be performed by authorized service technicians: check the instructions
for the amount of rinse-aid.
2. Check that there is rinse-aid in the container and if necessary top off level.
3. Check the set amount of rinse-aid (see "setting the dispensers" para-
graph).
4. Check that the water temperature is between 176°F [80°C] and 194°F
[90°C].
1. Check that there is rinse-aid in the container and if necessary top off level.
2. Check the set amount of rinse-aid (see "setting the dispensers" para-
graph).
3. Remove the rack of glasses immediately the cycle has ended.
1. Only use "non-foaming" products for professional dishwashers.
1. Check that the wash water temperature is not less than 122°F [50°C].
2. To be performed by authorized service technicians: check if the amount of
product dispensed by the detergent dispenser is excessive.
3. Ensure that the tank has not been cleaned with unsuitable cleaners. Drain
the tank and rinse thoroughly before new wash cycles.
4. If a foaming detergent has been used, drain and refill the tank with water
until the foam disappears.
1. Reduce the amount of rinse-aid (see "setting the dispensers" paragraph).
1. Remove and thoroughly clean the arms.
2. Clean the wash pump suction filter.
3. Run the De-Lime cycle.