Dash Disassembly; Kit Assembly - Mazda CX-5 2012-up Instrucciones De Instalación

Dash Disassembly

1. Unsnap and remove the trim
from above the glove box across
including the center climate vents
and hazard button (careful not to
cycle the key while the hazard
button is disconnected).
(Figure A)
2. Unsnap and remove the trim from
around the factory radio. Remove
the clips from the back of this
panel and attach them to the
Metra kit. (Figure B)
3. Remove the two screws securing
the factory radio and remove it.
Continue to kit assembly
(Figure A)
(Figure B)
95-7522B
1. Install the four included panel clips
to the back of the radio housing
trim panel (factory clips can also
be used if desired).
2. Attach the brackets to the radio
housing with the four supplied
truss head screws. (Figure A)
3. Slide the radio into the bracket
assembly and secure with screws
supplied with the radio. (Figure B)
4. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
5. Reassemble dash in reverse order
of disassembly.
2

Kit Assembly

(Figure A)
(Figure B)