Mestra R-100191 Manual De Instrucciones página 14

English
10. Close the cover of mixer properly. Make
sure whether the cover has been closed
properly. If not, the mixer can not be started
on.
11. Meet the mixing amount to set the required
time by timer (please refer to the "Setting
for Mixing Time"). When complete the
setting, then press down the start button
(Fig. 11). The digital display will coung
second by second
completion. The cover of mixer is fully
locked when running, so it is very safe as
unable to open.
! NOTA
Para protegen el motor, al arrancar se irá
ajustando la potencia gradualmente para
alcanzar la máxima
aproximadamente 2 segundos.
! IMPORTANT
If the mixing time advances the time
required, it is better tos et at shorthest time
since the time setting will be advanced.
14
Fig. 9
Fig. 10
till the time of
velocidad en
Fig. 11
! IMPORTANT
If intends to stop running, press down the
STOP button and the mixer will be stopped
immediately.
If finds any abnormal condition during
running, the mixer
immediately. Send it to repair.
12. After making sure that the mixer has been
stopped, the cover can be oponed to take
out the mixing bowl. Use the spatula to
have the mixture out (Fig. 12).
SETTING THE MIXINT TIME
1. The timer has 3 programs established by
the manufacturer that you can change.
Memory
1
2
3
2. Press down the button of MEMORY
SELECT to select the time required for
mixing.
3. To alter the memory of mixing time
established by the manufacturer, you can
do adjustment by pressing the button UP or
DOWN to key in the required mixing time.
The maximum time is 16 seconds. You can
make the adjustment second by second.
* The time setting for power of 50 Hz (the water
temperature is between 10 y 20 ºC) is listed as
below:
Alginate cups
1
2
3
shall be stopped
Fig. 12
Mixing time (seg.)
8
10
12
Mixing time (seg.)
7 - 10
8 - 11
9 - 12