Recording
you can make a recording of a tV program using a recorder.
Press the
REC button.
Recording begins. (Only when the Anynet
You can record the source streams by selecting "Record" after pressing the tOOLS button.
Pressing the REC button will record whatever you are currently watching. If you are watching video from another device, the
video from the device is recorded.
Before recording, check whether the antenna jack is properly connected to the recording device. To properly connect an
antenna to a recording device, refer to the recording devices users manual.
Listening through a Receiver (home theater)
You can listen to sound through a receiver instead of the TV speaker.
.
Press the tOOLS button. Then press the ENtER
Press the ▲ or ▼ button to select "Receiver", then press the ENtER
2.
Press the ◄ or ► button to select to "On", then press the ENtER
Now you can listen to sound through the receiver.
3.
Press the ExIt button to exit.
If your receiver supports audio only, it may not appear in the device list.
When listening through the receiver, there are restrictions for using the PIP and audio-related(MTS, Preferred language)
menus.
If there is a power interruption to the TV when the "Receiver" is set to "On" (by disconnecting the power cord or a power
failure), the "TV Speaker" may be set to "Off" when you turn the TV on again. (refer to page 37)
enabled recording device is connected.)
+
button to select "Anynet+(HDMI-CEC)".
English - 53
button.
button.