Campingaz BISTRO 300 STOPGAZ Instrucciones De Empleo página 7

Thank you for choosing this Campingaz
STOPGAZ™.
Figures: see pages 2 and 3.
® ®
BISTRO 300
Remove the device from its packaging.
(Where the existing cartridge is empty, read paragraph
D : "Changing the cartridge").
When installing or changing a cartridge, always operate
in a very well-ventilated location, preferably outside,
never near a flame, heat source or spark (cigarette,
electric apparatus, etc.) and far away from other people
and inflammable materials.
AS CAMPINGAZ
VALVE-OPERATED, THEY CAN
FROM THE EQUIPMENT, EASILY TRANSPORTED
(EVEN WHEN NOT EMPTY) AND FITTED TO OTHER
CAMPINGAZ
DESIGNED
THESE CARTRIDGES.
a) Check that the gas supply is fully turned off by turning
b) Remove the base (4) by turning it anti-clockwise then
c) Place the base (4) on a flat surface then put the
d) Holding the pot, insert the cylinder and the base
Place the pan support hooks in the slots located on each
side of the burner and turn the pan support clockwise to
lock it.
The equipment is ready for use.
In the event of leakage (smell of gas prior to turning the
tap on), take the equipment outside immediately, in a
well-ventilated area with no combustion source, where
the leak can be located and halted. If you wish to check
that your equipment is correctly sealed, do so outside.
Never attempt to locate leaks using a flame. Use gas
leak solution.
- 7 -
®
CV300 PLUS CARTRIDGES ARE
®
EQUIPMENT IN THE 300 PLUS RANGE
TO OPERATE
the control knob (1) clockwise (OFF position ''●'') (fig. 1).
take off the pot (7) (fig. 4).
cartridge (8) into the base inside the 4 tabs (P) (fig.
5). Press the cartridge down firmly to lock it in the
four teeth (G).
vertically inside it. Lock the base by screwing it in
completely, as indicated in figure 7.
BE DETACHED
EXCLUSIVELY WITH