Phoenix Gold Ti2800.1 Manual De Instrucciones página 2

SPECIFICA TIONS
Ti2 800.1 SPECIFICATIONS
Frequency Response:
Signal to Noise Ratio:
Low Pass Crossover:
Subsonic Filter:
Low Pass Crossover Range:
Subsonic Crossover Range:
Bass Boost @ 45Hz:
Low Level Input Range:
Lowest Recommend Load:
Typical Efficiency:
Damping Factor:
Variable Phase Adjustment:
Ti2 1300.1 SPECIFICATIONS
Frequency Response:
Signal to Noise Ratio:
Low Pass Crossover:
Subsonic Filter:
Low Pass Crossover Range:
Subsonic Crossover Range:
Bass Boost @ 45Hz:
Low Level Input Range:
Lowest Recommend Load:
Typical Efficiency:
Damping Factor:
Variable Phase Adjustment:
IMPORTANT: A power birth certificate is included for each amplifier. Ti2 amplifiers
are conservatively rated and will exceed their RMS power rating shown here. All
RMS power ratings and measurements are at 14.4 volts with no more than 1% THD.
Phoenix Gold • www.phoenixgold.com
RMS Power Output
± 1dB from 20Hz to 200Hz
>90dB
24dB per Octave
48dB per Octave Power/Ground Wire Size:
30Hz to 200Hz Recommend Power Wire Fuse:
10Hz to 55Hz Dimensions (Includes Feet):
0 to +18dB
200 millivolts to 8 volts
1 ohm
80%
Greater than 200
0 to 180 Degrees
± 1dB from 20Hz to 200Hz RMS Power Output
>90dB
24dB per Octave
Power/Ground Wire Size:
48dB per Octave
30Hz to 200Hz Recommend Power Wire Fuse:
10Hz to 55Hz Dimensions (Includes Feet):
0 to +18dB
200 millivolts to 8 volts
1 ohm
80%
Greater than 200
0 to 180 Degrees
Amplifier Owner's Manual
600w x 1 @ 2 ohms
800w x 1 @ 1 ohm
4 Gauge
80a
11.7" L x 7.1" W x 2.0" H
296mm L x 180mm W x 52mm H
900w x 1 @ 2 ohms
1300w x 1 @ 1 ohm
4 Gauge
100a
14.4" L x 7.1" W x 2.0" H
366mm L x 180mm W x 52mm H