Connecting Power; Getting Started; Turning The Unit On And Off; Setting The Source Mode - Naxa NHS-2012 Manual De Instrucciones

Connecting Power

Use the included AC power adapter to connect the unit
to AC household power.
• Connect the two-pronged end of the adapter to a
household power outlet.
• Connect the barrel plug end of the adapter to the
Power socket [6] of the unit.
The adapter supports AC 100-240V power
only. Do not connect the power adapter to
a power outlet other than that which is in-
dicated here and on the rating label of the
power adapter as this may result in the risk
of fire or electric shock.
Disconnect the unit from power if it will not
be used for a long time.
Do not handle the power plug with wet
hands. Doing so may cause electric shock.
Do not use the adapter with any other power
source.
Page 10

Getting Started

Turning the Unit On and O
To turn the unit on, press the STANDBY/SOURCE [7]
button.
To place the unit in Standby mode, press and hold
STANDBY/SOURCE [7] until the SOURCE LED [2] turns red.
To turn the unit off completely, disconnect the unit
from power.

Setting the Source Mode

Press STANDBY/SOURCE [7] to set the active source
mode. This controls which connection is being used.
The SOURCE LED [2] will light to indicate which mode
has been selected when STANDBY/SOURCE [7] is pressed.
Source LED
Blue Bluetooth
Indigo (blue + green) Optical IN [4]
AUX IN [5]
Violet
Connection Mode
®
Naxa Electronics