Using Optical In Mode; Connection; Using Aux In Mode; Aux In Sources May Include - Naxa NHS-2012 Manual De Instrucciones

Using Optical IN Mode

Connection

1. Follow the figure below to make the connections.
2. Turn the unit on. Press the STANDBY/SOURCE [7]
until the SOURCE LED indicator turns indigo.
Not all entertainment systems are setup
the same way; the diagram below is only
an example of a simple setup.
O P T IC A L I N
Optical Connection Cable
(not included)
Page 12
A U X I N
D C 5 . 8V, 2A
TV or DVD player etc.
OPTICAL OUT
Operate the external device as directed by its
manufacturer to control playback.
This optical connection only supports
the uncompressed PCM signal format.
You may need to adjust the digital
output format of your source device;
contact the device manufacturer to
learn more.

Using AUX IN Mode

AUX IN sources may include:

Rear
• Personal audio players, mobile phones
View
• Personal computers or laptops

AUX IN connection

1. Follow the figure below to make the connections.
2. Use a stereo 3.5mm to RCA jack cable (supplied)
to connect the RCA (Audio) output of the source
device (e.g., TV) to the AUX IN audio input jack
found on the back of the unit.
Naxa Electronics