Black and Decker TROS1000 Manual Del Usuario página 5

GETTING ST RTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting parts and set them aside in a safe place where they will not
roll away or get lost.
Important: Do not attempt to operate appliance until it is properly installed.
CHOOSE LOC TION
When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing
location.
• DO NOT mount over any heating or cooking appliance such as your range or
oven.
Note: Do not install closer than 4 inches to any vertical surface or to any
horizontal surface beneath the unit.
• DO NOT mount over or near a sink.
• DO NOT mount under, in front of or behind any under-cabinet light fixtures.
Note: If you are mounting multiple †SpaceMaker™ appliances (Fig. .):
• llow at least 4" between the side opposite the control panel of your oven and
the adjacent wall or the other appliance.
• llow at least 1" between the control panel side of your oven and the adjacent
wall or the other appliance.
4"
4"
.
8
1"
1"
Caution: This appliance features a Save- -Plug™ outlet receptacle to connect
smaller †SpaceMaker™ appliances such as the mini food processor / grinder or
can opener. Do not use this outlet for any other appliance!
Caution: When selecting a location for your toaster oven, make sure you have
adequate room to reach the Rear Receptacle.
Note: If you are connecting another †SpaceMaker™ appliance into the Save- -
Plug™ outlet, make sure you can easily unplug the appliance after each use.
DETERMINE C BINET TYPE
Prior to taping the mounting template and beginning to drill your holes, determine
if your cabinet has a flat bottom (B) or an overhang molding (C). If your cabinet is
flat, follow ST ND RD INST LL TION; if the cabinet has an overhang molding,
refer to OVERH NG MOLDING INST LL TION.
B
ST ND RD INST LL TION (FL T C BINET)
Important: lways wear protective glasses or goggles to prevent injury when
drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other
appliances or items. Open cabinets and remove contents to make mounting
easier.
2. Clean both the underside and topside of the bottom panel of the cabinet.
3. With cabinet doors open, place mounting template flush against the surface of
the underside of your cabinet, making sure to align thick line on template with
bottom front edge of your cabinet (D).
D
Important: Do not align screw holes on template directly under the partition
between cabinets, as this will prevent you from installing the appliance properly.
Pay close attention to where the drill holes will be set so as not to damage your
C
9