How To Charge; How To Connect - Audio-Technica ATH-ANC40BT Manual De Instrucciones

Auriculares inalámbricos cancelación de ruido
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
Fully charge the battery when using for the rst time.
When the rechargeable battery power runs low, you will hear a short beep and the indicator will ash red. When you hear
the beep, charge the battery.
It takes about 3 hours to charge the battery fully. (It varies depending on service conditions.)
* The headphones cannot be used during charging because Bluetooth is disconnected.
1 
Connect the included USB cable (the micro USB terminal side) to the headphone battery jack.
Computer
2 
Connect the USB cable (the Type A side) to the computer and start charging.
3 
During charging, the indicator operates as follows:
Lit red: Charging
Off: Charging complete

How to Connect

About Pairing
To connect the headphones to a Bluetooth device, the headphones need to pair (register) with the device. Once they are
paired, you don't need to pair them again.
However, you will need to pair again in the following cases:
・If the headphones are deleted from the Bluetooth device connection history,
・If the headphones are sent out for repair,
・If the headphones are paired with 9 devices or more.
(The headphones can be paired with up to 8 devices. When you pair with a new device after pairing with 8 devices, pairing
information for the device with the oldest connection date will be overwritten by information for the new device.)
How to Perform Pairing
* Read the user manual for the Bluetooth device.
* Place the Bluetooth device within 1 meter of the headphones to perform pairing correctly.
* Wear the headphones to con rm pairing by listening for sound.
1 
When these headphones are turned off, press and hold the power
button until the indicator on the Bluetooth transmitter/receiver
ashes red/blue (about 6 seconds).
1st beep
2 
Pairing process will begin and the Bluetooth device will search for the headphones.
* For more information on how to use the Bluetooth device, read the operation manual for the device.
USB port
Type A
USB charging cable (included)
A 2-second pause
Indicator
Micro USB terminal
2nd beep

How to Charge

Battery
jack
Long press
English
5

Publicidad

Tabla de contenido
loading

Tabla de contenido