How To Use; Power Supply - Audio-Technica ATH-ANC40BT Manual De Instrucciones

The indicator of the headphones displays the following operating status by ashing or turning on.
Operating status
Pairing
Searching for device*
Waiting to be
connected
Connect
Connecting
Remaining battery
Remaining
battery level level low
Charging
Charge
Full charge
* The lamp ashes red rapidly if you pair a device when the remaining battery level is low.

How to Use

The headphones are capable of making Bluetooth connections, playing music and receiving incoming calls.
Please use the headphones in accordance with applications. Please note
of applications of the Bluetooth

Power supply

ON : Press and hold the Power button (for about 4 seconds) to turn on the power.
* If the headphones are switched to pairing mode
by mistake, turn the power off and on again.
OFF : When the power is on, press and hold the Power button (for about 3 seconds) to shut off the power.
Using the Noise-Cancelling Function
Turn the NC switch ON. The NC indicator (green) lights when the NC switch is
turned ON.
The noise-cancelling function can be used when there is no Bluetooth device connected.
How to Wear
Wear the side of the headphones marked with "L" (left) on the left ear and the
side marked with "R" (right) on the right ear and adjust the earpieces for best t
(refer to "About the earpieces").
*Turn the volume of the connected device to the minimum level and put on
the headphones.
Indicator display patterns
device.
(Indicator: blue)
(Indicator: red)
About Indicator Display
Red Blue
Flashing
Lit
Off
that we cannot guarantee the operation
♪
Beep
♪
Beep
English
Long press
NC switch
NC indicator (green)
7