Temperature Settings; Time Settings; Steam Function - BaByliss PRO MiraCurl SteamTech BAB2665SE Manual Del Usuario

OPERATING INSTRUCTIONS
The MiraCurl™ SteamTech will cre-
ate many different curl effects in
the hair. It is easy to experiment
with the different settings to
achieve your desired results.
Always ensure that the sections of
hair you want to curl are no wider
than 2.5cm wide.
The type of curl will depend on
the temperature selected and the
timer setting, which dictates the
amount of time the hair is kept in-
side the curl chamber.

TEMPERATURE SETTINGS

There are 3 temperature settings
to select from 190°C, 210°C and
230°C. We recommend you always
start with the lowest temperature
setting and increase the level of
heat as required.
• Setting I (190°C) - for delicate, fine
or colored hair
• Setting II (210°C) - for normal tex-
tured hair
• Setting III (230°C) - for thick or
wavy hair

TIME SETTINGS

There are 3 time settings with an
automatic beep indicator. These
different settings will give different
curl effects. The longer the hair is
held inside the curl chamber, the
more defined the curl will be. But
results will also vary according to
hair type. Use the following as a
guide:
• Setting 8 (8 seconds = 3 beeps)
- for loose waves
• Setting 10 (10 seconds = 4 beeps)
- for soft curls
• Setting 12 (12 seconds = 5 beeps)
- for more defined curls
• At the end, there will be 4 quick
beeps in succession to indicate
time is up, and it's ready to re-
lease hair.

STEAM FUNCTION:

• Fill reservoir as described in "Filling
the Water Reservoir" below.
• Turn the machine on and allow
to heat (red light will stop blink-
ing) before turning on the steam
function. Steam function is not
recommended if the red light is
still blinking.
• Slide the steam
• If not using steam, make sure
switch is set to 0-OFF.
WARNING
• While emitting steam, always use
according to instructions, and
don't place appliance too close
to the head. Doing so could cause
burns to the skin, scalp, or eyes.
• Reduce any risk of contact with hot
mist emitted from steam vents by
testing steam option before each
use. Hold unit away from body be-
fore turning on steam option.
• Like any heating devices the sur-
face of the Miracurl™ SteamTech
may get hot, especially on the top
of the upper handle.
12
switch to ON.