Lutron QS Keyswitch Guia De Instalacion página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. Mount Keyswitch. Carefully mount and align
the keyswitch as shown. Screw top and bot-
tom screw into the control and wallbox. Replace
faceplate, adapter (insert version only), and insert
(insert version only).
Wallbox
Control link
wiring
Control
(included)
8. Turn Power ON. Turn ON control breaker, or
replace main fuse.
Notes
Unprogrammed (out of the box) QS keyswitches
and control units will all work together until they are
reprogrammed otherwise. Default programming is
Scene Mode, set to toggle between Scene 1 and
Off.
If the keyswitch is wired properly, the left LED will
flash when the key is turned to the left, and the
right LED will flash when the key is turned to the
right.
Installation Instructions
Faceplate
adapter
(included)
Faceplate
(included)
System Communications
In order for keyswitches to communicate with a
control unit, each keyswitch must be individually
configured to "talk" to a "listening" control unit.
(Only one keyswitch can be in setup mode at a
time.)
Programming to GRAFIK Eye
1. Enter Setup Mode. Press and hold the Program
Button on the keyswitch for 5 seconds. (Both LEDs
will flash continuously.)
Program button
4
QS
®
LED
LED
Occupant Copy

Publicidad

Tabla de contenido
loading

Tabla de contenido