Lighting The Side Burner - BRINKMAN 810-1750-S Manual Del Propietário

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or
the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care
and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and
Hose/Regulator to Grill.

LIGHTING THE SIDE BURNER:

1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn side burner control knob to the "HIGH" position.
4. Press the electronic igniter on the main control panel and hold
for 3 – 5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF",
wait 5 minutes to allow gas to dissipate and repeat lighting
procedure.
6. To turn off, turn each control knob clockwise until it locks in the
"OFF" position.
MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
4. Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is
found and corrected. See "Trouble Shooting" section of this manual.
Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the
flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and
Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to
Grill.
LIGHTING THE ROTISSERIE BURNER:
1. Open grill hood before lighting rotisserie burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn the control knob to the "HIGH" position.
Press electronic igniter for 3 – 5 seconds.
4. If ignition does NOT occur in 5 seconds, turn control knob
to "OFF", wait 5 minutes to allow gas to dissipate and repeat lighting
procedure.
5. To turn off, turn control knob clockwise until it locks in the "OFF"
position.
IMPORTANT: DO NOT use back rotisserie burner when main burners are in use.
11