Emtec H610 Manual Del Usuario página 8

EN
REC (record): This key works the same way as the one on your original remote
for your VCR.
[18] Navigation keys :Allows to move in the menu.
[19] Color keys: allows to control Teletex (Fasttext) or special TV functions.
2) Programming
Note: You can dedicate any appliance (TV, DVD, SAT...Emtec Movie Cube) to
the TV, DVST, VCR, CBL, DVD, AMP, AUX and SAT keys: you just need to
enter the 4 digit code (found in the code book) of the appliance, i.e. a Emtec
Movie Cube code under the SAT key.
In any case, follow the steps below:
1. Make sure your equipment is switched on (for example TV).
2. Press and hold the SETUP key for 3 seconds under the STANDBY key remain
lighten permanently Release the SETUP key.
3. Press and release the MODE key of the device you want to control (for example
TV). Apply on H620, H640 and H680 models only. You can go to next step
directly if you are using model H610.
4. Enter the 4 digit code from the Code Book.
If you entered a wrong code the STANDBY key will turn off and you will have
to repeat from step 2;
If you entered the correct code the STANDBY key blinks for 3 seconds and then
turns off.
5. Point the remote in the direction of your TV and press the STANDBY button.
Your device should turn off. Check other functions (for example for a VCR: FF or
REW etc.). If certain functions are not responding this indicates that the entered
code is not the correct one. In that case repeat the above procedure with the next
corresponding code of your brand.
6. Repeat this procedure from step 1 for the other equipment you want to control
3) Automatic code search
When searching an unknown code, you can step through the library automatically
(AutoSearch). When your equipment responds, you can stop the searching
process and store the code you found.
Note: As you can dedicate any appliance (TV, DVD, SAT...) to the keys, you need
first to enter any 4 digit code for the kind of appliance you wish to control (found
in the code book, i.e.:
If you want to program a SAT under the VCR key, enter any SAT code found in
the code book and then follow the steps below:
1. Turn on the device you want to control.
2. Press and hold SETUP for 3 seconds until the STANDBY key remain lighthen
permanently.
3. Press the mode key that matches the equipment you want to control (for
example TV). Apply on H620, H640 and H680 models only. You can go to next
step directly if you are using model H610.
4. Press once the SETUP key. After a few seconds the remote starts to search and
scan all codes available in the library (fast search, 1 code every 2 seconds). The
STANDBY key blinks every 2 seconds. Once the appliance turns off you need to
press SETUP immediately to save the code and stop the search. The STANDBY
key will blink 3 times and then turns off. The code is saved.
To cancel without saving a code, press STANDBY. The STANDBY key will turn
off.
4) Brand search
If your brand is listed hereafter, you have the possibility to use the brand search
method (faster than the «manual» and the «automatic code search»):