Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Your c leaning system requires some assembly andisready
foruse onlyafter i t hasbeen properly serviced withthe
recommended
oilandfuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKTHE PRESSURE WASHER
8.
Attach nozzleextension to spray gun.
9.
Select/attach quick connect spray tip to nozzle extension.
Attach Handle and Cleaning Tank
1.
Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents, if any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
*
Main Unit
*
Handle
*
Cleaning Tank Assembly
*
High Pressure Hose
*
Spray Gun
*
NozzleExtensionwith Quick Connect Fitting
*
Oil Bottle
*
DetergentSiphoning Hose/Filter
*
Gun Holder Wireform
*
Parts Bag (which includes the following):
*
Operator's Manual
*
Owner's Registration Card
*
Safety Goggles
*
Bagcontaining 4 multi-colored Spray Tips
*
HandleFasteningHardwareKit (which includes):
*
Carriage Bolts (2)
*
"L" Bolt
*
Plastic Knobs (4)
,
Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly before
operation:
1.
Fill out and send in registration card.
2.
Attach handle and cleaning tank.
3.
Connect detergent siphon hose to pump.
4.
Add oil to engine crankcase.
5.
Add fuel to fuel tank.
6.
Connect pressure hose to spray gun and pump.
7.
Connect water supply to pump.
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriage bolts (B) through holes from back of unit
and attach a plastic knob (E) from front of unit. Tighten
by hand.
Placecleaning tank (F) over holes (6) on handle
(viewing from front of unit). Push the tree clips (H) into
the holes until they sit flat against the cleaning tank.
"-.
/,
Insert "L" bolt (J) through hole just above cleaning tank
on right side of handle (viewing from front of unit). Hold
bolt in place and attach plastic knob (K) from inside of
unit. Tighten by hand.
Publicidad
Tabla de contenido
