Unpackthe Pressure Washer; Attach Handle And Accessory Tray; Carton Contents - Craftsman 580.752212 Instrucciones De Uso

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1-800-222-3136.
UNPACKTHE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• Accessory Tray
• High Pressure Hose
• Spray Gun
• Nozzle Extensionwith Quick Connect Fitting
• Oil Bottle
• Hose Wrap
• DetergentSiphoning Hose/Filter
• Bottle Bracket Wireform (2)
• PerfectMix
TM
Siphoning Unit/Hose
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 5 PrecisionSprai MNozzles
• HandleFasteningHardwareKit (which includes):
• Handle Bolts (2)
• Carriage Bolt (2)
• Rope Guide (1)
• Plastic Knobs for Handle (2)
• Plastic Knob (3)
• Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer Identify all contents with the illustration on
page 6 If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1 Fill out and send in registration card
2 Attach handle and accessory tray
3 Connect detergent siphon hose to pump
4 Add oil to engine crankcase
5 Add fuel to fuel tank
6 Connect pressure hose to spray gun and pump
7 Connectwater supply to pump
8 Attach nozzleextension to spray gun
9 Select/attach quick connect PrecisionSpray
TM
nozzle to
nozzle extension
Attach Handle and Accessory Tray
1 Place handle (A) onto handle supports (B) connected to
main unit Make sure holes (6) in handle align with holes
(6) on handle supports
,
,
Insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E) from outside
of unit Tighten by hand By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store flat atop the cold engine Note:
DO NOTfold the handle down while the engine is hot
Placeaccessory tray (F) over holes (6) on handle
(viewing from back of unit) Push the tree clips (H) into
the holes until they sit flat against the accessory tray
,
/
Insert multi-colored PrecisionSprai Mnozzlesand other
supplied accessories in spaces provided in accessory
tray See How to Use Accessory Tray